Universal Remote Control (URS) URC-SR3 User Manual

Page 10

Page 10

If the Three Digit Code did not
work, try this next:

Auto-Search Method
The Auto-Search Method is a way you can scan
through all of the codes in the table to find the right
code for your component.
STEP 1: Manually or using your old remote, turn
on the component you want to program—for
example, to program your TV, turn on your TV set.
STEP 2: On the URC-SR3, press the Component
button that you want to program (in this case the
button that says TV) and the SELECT [SEL] button at
the same time. Hold down both buttons for 2
seconds until the TV Component button light turns
on. This signals that you are in programming
mode.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.

STEP 3: Point the URC-SR3 remote control toward
the component and press the UP

arrow (or

DOWN

arrow) button once. Each time the

or DOWN

arrow button is pressed, the

code will count up (or down) one code number
and send a Power OFF signal. When the correct
code is sent out, the component will turn off.

DOWN

ARROW