Uniden DECT2085 User Manual

Page 53

Using the

Answering

System

To.operate.from.a.remote.location,.use.any.touch-tone.telephone,.and.follow.these.steps:

Call.your.telephone.number.and.wait.for.the.system.to.answer..If.the.answering.system.is.off,.it.will.answer.after.
about.ten.rings.and.sounds.a.series.of.beeps.

During.the.greeting.or.the.beeps.(if.answering.system.is.off),.press.[0].and.enter.your.security.code/PIN.within.
two.seconds.

The.answering.system.announces.the.current.time.and.the.number.of.messages.stored.in.memory..
You.hear.“To.play.incoming.messages,.press.zero-two..For.help,.press.one-zero”.followed.by.a.beep.
Enter a remote command from the chart below. You have fifteen seconds to enter the first command; after the

first command, you have two seconds to enter each command.
Remote Commands

Command

Function

Command

Function

Command

Function

[0].then.[1] Repeat.a.message*

[0].then.[4] Delete.a.message

[0].then.[9] Answering.system.off

[0].then.[2] Play.incoming.messages

[0].then.[5] Stop.operation

[1].then.[0] Help

[0].then.[3] Skip.a.message

[0].then.[6] Answering.system.on

*.If.you.press.[0].then.[1]

in the first four seconds of a message, the system skips to the previous message..

If.you.press.[0].then.[1]

after the first four seconds of a message, the system repeats the current message.

When you finish, you will hear intermittent beeps indicating that the system is in the command waiting mode.

Enter another command from the chart within fifteen seconds.
Hang.up.to.exit.the.system..The.answering.system.automatically.returns.to.its.normal.standby.setting.

)