Trimble Outdoors SPSX51 User Manual
Page 67
SPSx51 Modular GPS Receivers User Guide
65
Configuring the Receiver Using the Keypad and Display
6
8.
Press
G
to move the cursor to the next character.
9.
Repeat
to enter the code of the base station. The code can
be up to 16 characters.
10. Press
L
to accept the change.
11. Press
L
again. The Base Latitude screen appears. See next.
Setting the reference latitude, longitude, and height of the base station
In the Base Latitude screen:
1.
The base was set up with a “Here” position, so press
L
.
2.
The Base Longitude screen is used to change the reference longitude of the base
station. The base was set up with a “Here” position, so press
L
.
3.
The Point Height screen is used to change the reference height of the base
station. The base was set up with a “Here” position, so press
L
.
4.
Use the Antenna Type screen to select the type of antenna used with the receiver.
Press
G
. When the antenna name begins to flash, the receiver is in Edit mode
and you can select an antenna.
5.
Press
K
to scroll through the antenna models.
6.
Once the correct antenna name appears, press
L
to accept the change.
7.
Press
L
again. The Measured To screen appears. See next.
Measuring and changing the antenna height
In the Measured To screen:
1.
Press
G
. When the antenna measurement method begins to flash, the receiver
is in Edit mode and you can select an antenna measurement method.
2.
Press
K
to scroll through the measurement methods. Once the correct
measurement method appears, press
L
to accept the change.
3.
Press
L
.
4.
Use the Antenna Height screen to change the height of the antenna. Press
L
.
When the first character of the antenna height begins to flash, the receiver is in
Edit mode and you can change the antenna height.
5.
Press
J
or
K
to change the value of the character.
6.
Press
G
to move the cursor to the next character.
7.
Repeat
through
to enter the height of the antenna.
8.
Press
L
to accept the change.
9.
Press
L
again. The Output screen appears. See next.