Forcing the receiver into monitor mode – Trimble Outdoors SPSX51 User Manual
Page 165

SPSx51 Modular GPS Receivers User Guide
163
Upgrading the Receiver Firmware
F
The Settings Review window appears. This screen prompts you to connect the
receiver, suggests a connection method, and then lists the receiver configuration
and selected operation.
7.
If all is correct, click
Finish
.
Based on the selections shown above, the Software Upgrade window appears and
shows the status of the operation ( for example,
Establishing communication
with
.).
8.
Click
OK
.
The Software Upgrade window appears again and states that the operation was
completed successfully.
9.
To select another operation, click
Menu
; to quit, click
Exit
.
If you click
Exit
, the system prompts you to confirm.
10. Click
OK
.
Forcing the receiver into Monitor mode
If the receiver will not go into Monitor mode to load new firmware, complete the
following steps:
1.
Turn off the receiver.
2.
Press and hold
F
while turning on the receiver.
3.
Continue to hold the
F
button as the display shows the countdown timer.
4.
Once the display shows
Remote Monitor Active:1
, release the
F
button.
5.
The receiver is forced into Monitor mode and you can load the new firmware.