Toshiba RD-XV47KE - Manual (Page 17)

17 EN
In
trod
uct
ion
Connecti
o
ns
Bas
ic Setup
P
layback
Ed
iti
n
g
V
CR Fu
ncti
on
s
O
th
ers
Fu
nc
ti
on
Set
u
p
Recordi
n
g
Rear Panel
1 Mains cable:
Connect to a standard AC outlet.
2 AV2(DECODER) (HDD/DVD/VCR):
Connect to VCR, camcorder, or other
Audio-Video equipment. Use a commercially
available Scart cable.
3 AV1(TV) (HDD/DVD/VCR):
Connect to the Scart socket on your TV. Use a
commercially available Scart cable.
4 DIGITAL AUDIO OUT (COAXIAL) jack
(HDD/DVD):
Connect to an amplifier with a digital input jack
such as a Dolby Digital decoder, DTS decoder or
MPEG decoder. Use a commercially available
Coaxial cable.
5 AUDIO OUT jacks (HDD/DVD):
Connect to the audio input jacks on your TV. Use
a commercially available Audio cable.
6 S-VIDEO OUT jack (HDD/DVD):
Connect to the S-Video input jack on your TV.
Use a commercially available S-Video cable.
7 COMPONENT VIDEO OUT jacks
(HDD/DVD):
Connect to an optional component video cable
through the component video input jacks of a TV.
8 ANTENNA IN (HDD/DVD/VCR):
Connect to an antenna cable.
9 ANTENNA OUT (HDD/DVD/VCR):
Connect to the Aerial jack on your TV, cable box
or direct broadcast system.
Use the supplied RF cable.
Note
• Do not touch the inner pins of the jacks on the rear panel.
Electrostatic discharge may cause permanent damage to the unit.
• This unit does not have an RF modulator.
OUT
HDD / DVD / VCR
ANTENNA
AV2 (DECODER)
AV1 (TV)
AUDIO
OUT
L
R
Y
P B
/C B
P R /C R
S-VIDEO
OUT
COMPONENT
VIDEO OUT
HDD/DVD
DIGITAL
AUDIO OUT
COAXIAL
IN
8 7 2 1 3 4 5 9 6
E3B90ED_EN.book Page 17 Friday, February 23, 2007 12:38 PM