TROY Group Bluetooth Print Adapter - Manual (Page 9)

Connecting to the Printer
Before connecting the WindConnect Bluetooth Print Adapter, make sure that the
printer is turned off.
The WindConnect has a 36-pin male Centronics parallel connector that is compat-
ible with the 36-pin female connectors found on most printers. Therefore, the
WindConnect can be plugged directly into the printer with no additional cable
required.
You are now ready to apply power to the WindConnect. Plug the power supply
into the wall, connect it to the WindConnect, and then turn on the printer.
Verifying Successful Installation
When you power it on, the WindConnect will go through the following startup
sequence:
◗ It runs through a set of power-up diagnostics for a few seconds. If the
WindConnect is operating properly, the green light will blink momentarily
and then go out. If the green light blinks continuously in a regular pattern,
there is a problem. Try unplugging the power supply and then plugging it in
again. If the problem persists, contact TROY.
◗ When the laptop makes a Bluetooth connection to the WindConnect, the
green light will stay lit. The yellow light will blink whenever there is print-
1-3