TROY Group Bluetooth Print Adapter - Manual (Page 10)

1-4
ing activity. Since you have not made a connection yet, both of these LEDs
should be off.
Verifying the Connection to the Printer
Before attempting to print, it is very important to verify the connection between
the WindConnect and the printer. If this connection is not good you will not be
able to print!
To verify this connection, make sure that both the WindConnect and the printer
are powered on and ready. Then print a test page by holding in the test switch for
less than five seconds.
If the test page does not print, first check to make sure that the WindConnect is
securely connected to the printer. Also, make sure that the printer is operating
properly and that it is not out of ink. Then power the WindConnect Print
Adapter off and then on again, and try printing the self-test page again.
If you cannot print a test page, contact TROY as described in the Where to Get
Help section of this guide.