Toshiba IK-DF02A - Manual (Page 8)

- 7 -
4-2. Line lock Control
• Matching the vertical synchronization with the power frequency is called the Line Lock.
• To activate the line lock, set the LL switch to ON.
• When two or more cameras are switched by the video switcher for viewing with a display monitor
the vertical synchronization phase can be locked to the power frequency for a stable vertical
synchronization.
Line Lock
1
ON
OFF
2 3 4
Note:
• The camera is synchronized to the power frequency of 60
±
1 Hz covering a normal fluctuation of
the power frequency. However, the camera may not cover a large fluctuation caused from the
power generated by a generator, etc.
• It takes approximately 10 seconds or more until a stable synchronization is obtained after the
power is turned on. This is normal, because several seconds are required to stabilize the camera
against power noise.
• Refer to section 7. "LINE LOCK PHASE" for adjustment instructions.
Display Monitor
Video Switcher
BNC Connector
Connector
Camera 1
To 24V AC UL Listed
Class 2 power supply.
Camera 2
• When connecting to DC power supply,
the Line Lock function is not activated.