Toshiba IK-DF02A - Manual (Page 6)

- 5 -
1
ON
OFF
2 3 4
3. PART NAMES AND FUNCTIONS
Pan ADJ Screw
Turn the ring-type screw to
adjust the lens pan angle.
Fasten and lock it after
completing the adjustment.
Power Input
Wire
Connect the power
cable to 24V AC or
12V DC.
Length: approx.
12 inches (300mm)
Video Wire (BNC Tap)
Connect the video cable to a
monitor or video device.
The image is outputted when
powered on.
Length: approx. 12 inches (300mm)
Lens Iris ADJ
Use to compensate for
the iris level.
Turn toward L (low) for a
darker picture.
Turn toward H (high) for a
brighter picture.
Optimum value is
adjusted at the default
setting.
V Phase ADJ
Adjust the phase
difference between this
camera and other
cameras in Line Lock
mode.
Mode Setting Switch
1: BLC (Backlight Compensation Control)
When switched on, it automatically
adjusts to compensate for subjects
that are lit from behind.
2: AGC (Auto Gain Control)
When switched on, it automatically
adjusts the image in relation to the
brightness of the subject.
3: DC/AES
Not available for this camera.
Be sure to switch to ON.
4: LL (Line Lock)
When switched on, its function is
activated. Line Lock is available
with 24V AC only.
Tilt ADJ Screws
Turn the screws to adjust the lens
tilt angle. Fasten and lock them
after completing the adjustment.
Horizontal ADJ Ring
Turn the ring to adjust the
horizontal angle of image.
MON (Monitor Out)
When installing the camera, it is
available to check the image with
monitor out harness wire.