TANDBERG 1000 MXP - Manual (Page 42)

D1372202_T1000_MXP_User_Manual
34
TTL/Router
Hops
This is used for streaming data to limit how many routers the data
should pass before it is rejected. If TTL is set to 2, data will not traverse
more than 2 router hops.
Streaming
Source*

Auto: Enables streaming of both local and far end video.
Selection of which site to be streamed is done using voice
switching (the site that speaks is streamed).

Local: Only the local video will be streamed.

Remote: Only the far end video will be streamed.
Local and far end audio is always streamed.
Allow Remote
Start

On: Streaming can be started from external user interfaces like
the Web-browser or Telnet session.

Off: Streaming can only be started from the Video Conferencing
System User Interface using the remote control, or by using the
Data port. This will prevent activation of streaming using Web
browser or Telnet sessions. See also Password section below
Announcements

On: The codec will announce to the network that it is streaming.
This enables a streaming client (e.g. a PC) to connect to the
codec
’
s streaming session. Used by Cisco IP/TV.

Off: No announcement packets will be transmitted.
Video Rate
Defines the Video streaming rate from the system. Range is 16 kbps -
320 kbps. In addition, audio (G.711) streaming rate is 64 kbps, providing
a maximum streaming rate of 384 kbps.
Streaming
Password
Set password so that only participants entering correct password will be
able to view the streaming session. Entering a password will prevent
unauthorized people from accessing the streaming session.
*The streaming source setting is not available when streaming only is supported outside a call.