TANDBERG 1000 MXP - Manual (Page 12)

D1372202_T1000_MXP_User_Manual
4
1.1 At a Glance
Camera
The camera is an integrated part of the unit
and is centrally placed just above the
monitor.
Monitor
The Digital LCD displays the far-end and
near-end videoconferencing sites in
addition to the menu.
Codec
The codec is the heart of the system. Its
main task is the compression of outgoing
video, audio and data, the transmission of
this information to the far end and the
decompression of the incoming information
- the name codec comes from a
combination of the two words compression
and decompression.
Microphone
The microphone is integrated and located at the edge on the left hand side of the unit.
Headset / push-button
For privacy, a headset may be connected to the connector (audio in and out) located at the edge
on the left hand side of the unit. The push-button on the front panel will toggle between internal
microphone/loudspeaker and the headset.
Remote Control
The remote control is used to control all functions of the system. If the screen saver is activated
(black monitor), touching the remote control will automatically wake up the system. The remote
control uses 4 AAA batteries. The system will tell you when batteries are running low. Change the
batteries at the back of the remote control.
The reach of the remote control signal is 20 meters. For users sitting in an open plan office, this
can cause problems. Use the little, white switch placed under the batteries to change the reach of
the signal from 20 meters to 2 meters. This will prevent you from unintentionally controlling
another video system, when you control your own system.