TANDBERG 1000 MXP - Manual (Page 111)

Administrator Settings
103
4.1.6 Permissions
Permissions contains settings for incoming telephone Calls, Far End Control, Remote Software
Upgrade and Fallback to Telephony.
Access Code
An access code will help you control the use of the system. All users must enter a code to identify
themselves and the call will be charged on their account. Access Codes are handy for group
systems where there are more users or divisions that share the costs of using the system. Access
Code can be set to "On" and "Off". Please refer to section
Appendix 5 for more information on
Access codes.
On When making a call, an Access Code dialog box will be shown. The user must enter
the correct password in order to put the call through.
Off No password is necessary to make a call.
Incoming Telephone Calls
On The system will accept incoming telephone calls.
Off The system will not accept incoming telephone calls. This is useful to prevent
incoming calls from systems other than videoconferencing systems.
Far End Camera Control
On The far end will be able to:
•
Control your camera
•
Select your video sources
•
Activate your camera presets
•
Request snapshots
Off The far end can access none of the four features above on the local system. You will
however still be able to control the camera on the far end.
Remote Software Upgrade
It is possible to upgrade software remotely, i.e. a far end system may upgrade software on a local
system via http on ISDN. The system to be upgraded must be configured to allow remote
software upgrade. It is possible to set a password which is needed for the far end system to be
able to accomplish the software upgrade.