Toshiba TEC H-9100N - Manual (Page 75)

13. OPERATING PROCEDURES
13.6 TARE/SAVE FUNCTION PROCEDURES
13- 11
13.6 TARE/SAVE FUNCTION PROCEDURES
Menu: REG., M.DOWN, or REWRAP
Mode: WEIGH or FIX (Tare % function is available in WEIGH mode only.)
NOTES: 1. Tare subtraction is available up to 4.00 lb. for the US type, and up to 2.000kg (4.00lb) for the CA type. When tare
subtraction is in operation, however, the scalable range for net weight becomes less by the amount of the tare. (Net
weight=Gross weight-Tare)
2. Preset tare must be a multiple of 5 g for CA type (Kg scale) and a multiple of 0.01 lb for US/CA type (Lb scale).
3. The tare % function is available when the Initial Setting #28-4 is set to 1. The speed key #108 will function as the % key
(Refer to page 5-3). Set a tare % within the range from 0.0 to 99.9.
4. When a commodity is placed on the platter and the calculated tare exceeds the maximum, a TARE WEIGH OVER
error will occur.
There are two kinds of tare subtraction procedures, one is “Direct tare”, the other is “Preset tare ”The
key is used to save the tare, unit price, and PLU data after taking a commodity from the platter. SAVE
0.200 lb
Place a container on the
platter.
(Ex. 0.200 lb)
Enter the PLU #.
Press:
The PLU data and tare are
saved.
Place a commodity into the
container.
(Ex. 1.000 lb)
T
SAVE
PLU
Place a container on
the platter
2 0 0
T
Press:
The label is issued.
Remove the commodity
together with the container.
C
MANUAL:
:AUTO
Press:
Press:
PLU
T
PLU
Press:
Press :
Press:
Press
:
CA type US type
0 Press:
Remove the Commodity
together with the container.
C
%
%
1 0 0
%
Tare %
Tare %
1 0 0
PRT
*
1 0 0