Toshiba TEC H-9100N - Manual (Page 44)

10. PROGRAMMING PROCEDURES
10.13 CMT/PL-3
10-22
Table 4: Transmission Item List
ITEM # Title on the Display Contents of Transmission CMT PL-3
2 VERIFY PLU & ING. = CMT 2 COMPARE PLU & ING. IN OLD FORMAT
3 READ PLU & ING. FM CMT 3 READ PLU & ING. IN OLD FORMAT
4 WRITE PLU TO CMT 4 SAVE PLU IN NEW FORMAT
5 VERIFY PLU = CMT 5 COMPARE PLU IN NEW FORMAT
6 READ PLU FROM CMT 6 READ PLU IN NEW FORMAT
7 WRITE ING. TO CMT 7 SAVE ING. IN NEW FORMAT
8 VERIFY ING. = CMT 8 COMPARE ING. IN NEW FORMAT
9 READ ING. FROM CMT 9 READ ING. IN NEW FORMAT
10 WRITE NUTRI. TO CMT 10 SAVE NUTRITION IN NEW FORMAT
11 VERIFY NUTRI. = CMT 11 COMPARE NUTRITION IN NEW FORMAT
12 READ NUTRI. FM CMT 12 READ NUTRITION IN NEW FORMAT
13 WRITE SPEED KEY 13 SAVE SPEED KEY IN NEW FORMAT
14 VERIFY SPEED KEY 14 COMPARE SPEED KEY IN NEW FORMAT
15 READ SPEED KEY 15 READ SPEED KEY IN NEW FORMAT
NOTE: When the PL-3 is required, FDK varies depending on the volume of ING. data.
Be careful of the following when changing a FDK.
a: During the write operation, replace the FDK with a formatted one.
b: Verify and read data in the same order as the write.
To cancel to change a FDK, press the key. CLEAR
: operable, : inoperable