beautypg.com

Operating procedures – Toshiba TEC H-9100N User Manual

Page 65

background image

13. OPERATING PROCEDURES

NOTES BEFORE STARTING OPERATION

13- 1

13. OPERATING PROCEDURES

NOTES BEFORE STARTING OPERATION

How to access REG., M.DOWN, or REWRAP menu

(1) Turn the power ON.
(2) A sixteen-second scanning will be performed after pressing the

key.

(3) Should a power failure occur during the operation, remove the commodity from the platter

and insert the power plug into an AC outlet again when power is restored.

(4) If the scale is used with an unrated power source, inaccurate scaling or other errors may

occur.

(5) If the zero point has shifted while scaling, and no tare is displayed, adjust the zero point

by pressing the

key.

(6) Check the date of the scale before the daily operation.
(7) Make a test print before operation every day.

Press the

key, and the test label is issued.

ZERO

TEST

POWER

The following display is displayed on the REG. menu display. When this display is shown
after pressing the

key, you can start the REG. operation right away.

POWER

NOTE: If a label nothing is printed on is issued after a printed label in batch mode, refer to

Section 10.11 and press the

key.

SET NEXT

To access a menu from other menus, press the

key to show the Main menu and enter

the menu No. When the MARK DOWN and REWRAP menus are protected, enter the menu
No. and then the password.

MAIN
0. PROG.

5. READ

1. REG.

6. RESET

2. MARK DOWN

7.

3. REWRAP

8.

4. SECURITY

9.

ESC

.

lb

UNIT/$

TOTAL $

0.000

P

000000

MENU WEIGH

ENTER THE PLU#

This manual is related to the following products: