Toshiba Multiprotocol Ethernet Interface for Toshiba G9/VFAS1 Adjustable Speed Drives ASD-G9ETH - Manual (Page 99)

98
ICC
Figure 111: XIO Instruction Selection
5) Configure the MSG instruction.
a) Set the “Read/Write” field to “Read”, “Target Device” field to “PLC5”,
“Local/Remote” field to “Local”, and “Control Block” to “N20:0”.
b) Upon hitting the key while in the “Control Block” entry box, the
MSG Properties dialog box should appear (or it can be opened by clicking
on the “Setup Screen” button at the bottom of the MSG instruction). Refer
to Figure 112.
Figure 112: MSG Configuration, "General" Tab