TRENDnet TVP-224HR - Manual (Page 115)

TVP-224HR User’s Guide
115
Appendix B - Connecting through Console
The console port uses a DB-9 RS-232 connector. The supplied straight through RS-
232 cable connects the console port of the TVP-224HR to a console PC or terminal.
Task Prompt Type
Connect RS-323 Cable to TVP-224HR RS-232
console port a your computer that you will use as
a configuring terminal
Open HyperTerminal and enter the following Input
Parameters when prompted: Baud rate
Number of data
bit
Parity check
Number of stop
bit
Flow control
19,200
8
None
1
None
When the empty HyperTerminal Screen appears
type “123” 123
In the event that you forget your administration
password, you can gain console access to the
TVP-224HR using the super password. The super
password is the last six digits of your MAC
address located on the bottom of your TVP-224HR
(00-50-2d-xx-xx-xx). At the Console prompt enter
the super password without hyphens. The
password is all lower case. After gaining access,
at the console prompt type in
net set manager password
net store
net reset
If entry of new password is successful, the console
will list “OK”. You will now be able to gain Web
Access from a PC in the same local segment
using the TVP-224HR LAN IP Address. If Web
and / or Telnet Access are enabled, you will also
be able to remote access the TVP-224HR by
entering http:// followed by the TVP-224HR WAN
IP or domain name.
At the prompt
Console>
Enter ping 168.95.1.1
The following dialogue indicates that Internet
Access is successful.
Console>
ping
168.95.1.1