Toshiba 120/150 - Manual (Page 73)

7-22
INSTALL THE SOFTWARE
Using the SCANNER key to begin scanning
• Scanning is not possible during a copy job.
• If the unit is used to begin a scan job during a print job, the scan job will be stored and
scanning will begin when the print job is completed.
1 Press the SCANNER ( ) key.
The unit enters scan mode.
2 Place the original you wish to scan on the original table.
For the procedure for placing the original, see “ORIGINAL PLACEMENT” (page 3-5)
3 Press the up copy quantity key to display the number
of the application that you wish to use for scanning.
The application numbers are initially as follows.
Application number Application launched
SC1 Desktop Document Manager (if installed)
SC2 E-mail (your standard e-mail program in the Windows OS you are using)
SC3 Fax (if a fax program is installed)
SC4 OCR (if an OCR program is installed)
SC5 Microsoft Word (if installed)
SC6 Any application set in Button Manager