Tektronix Phaser Color Printer 750 - Manual (Page 47)

42 Phaser 750 Color Printer
Disabling and Enabling Protocols
Disabling and Enabling Protocols
After your network configuration is complete, you may want to disable protocols that you
are not using to avoid unnecessary network traffic. There are four ways to disable
protocols:
■ Use the printer’s front panel; see Disabling and enabling protocols: Phaser 750 front
panel on page 43.
■ In NetWare environments, you can use the PhaserShare Administrator; see Disabling
protocols: PhaserShare Administrator on page 43.
■ With a TCP/IP connection and a World Wide Web browser, you can use PhaserLink
Printer Management Software; see Disabling protocols: PhaserLink Printer
Management Software on page 44.
■ Send the appropriate PostScript utility file to the printer. See the README files on
the printer’s CD-ROM. The PC README file is in the UTILS directory; the Macintosh
README file is in the Network Utilities folder.
You can enable protocols by the same procedures; just select the command to enable a
protocol rather than disable it.
Determining which protocols are enabled
All protocols can be enabled and disabled. The Configuration Page reports which
protocols are enabled. If a protocol is enabled, the field for that protocol lists the current
parameters. If the protocol is disabled, the field for that protocol contains an entry reading
Disabled.