Toshiba TDP-P4 - Manual (Page 32)

30
M a i n t e n a n c e & T r o u b l e s h o o t i n g
7 Install the new lamp module.
8 Tighten the screw on the outside of the module.
9 Press the yellow tab to reconnect the lamp module.
10 Replace the lamp access grill by lining up the ribs on the grill
with the marks on the bottom case and sliding the grill in the
direction of the arrows on the bottom case.
11 Plug in the power cord and press the Power switch to turn the
projector back on.
12 To reset the lamp hour counter in the Status menu, press and
hold the
RESYNC button, then press the MENU button (while
still holding down the RESYNC button) for 10 seconds.
Verify that the counter was reset by pressing the MENU button
and viewing the counter in the Status menu. See page 25 for
details on the Status menu.