Toshiba 32ZT29B - Manual (Page 32)

32
Selecting the character set and viewing mode and general information
This TV has a multi-page teletext memory, which takes a few moments to load and it offers two ways of
viewing text – AUTO and LIST which are explained on the next page.
analogue teletext – setting up
The 6 / 7 button:
Pressing the 6 / 7 button once will bring up the teletext
screen. Press again to superimpose the teletext over a
normal broadcast picture. Press again to return to normal
TV mode. You need to return to normal viewing if you
wish to change programmes.
When you first press the 6 / 7 button to access the text
service, the first page you see will be the initial page.
In AUTO mode this displays the main subjects available and
their relevant page numbers.
In LIST mode you will see whichever page number is
currently stored on the RED button.
To access any teletext page, enter the 3 digit page number,
using the numbered buttons on the remote control,
e.g. 430, or to advance to the next page press the
P
f ( or P ) button, to go back to the previous page press
the P e (or Q ) button.
Sub-pages
Once in this chosen page, if there are sub-pages they will
automatically load into memory without changing the
one you are reading. Arrows will appear along side the
page number, indicating sub-pages which have loaded to
the left or right of the one on the screen. If there are many
sub-pages it will take a long time for them all to load and
this will depend on the speed with which the broadcaster
transmits them.
To access the sub-pages in memory press the
X X ( B B ) button, then use the
S Sand R R buttons to
view them.
Whilst in sub-pages mode an indicator will show in the
bottom left of the screen. After a short time of inactivity the
indicator will disappear. To access the sub-pages again press
the
X ( B ) button.
These sub-pages will remain available to view until you
choose another page or, in normal TV mode, you change
programme.
About teletext
Selecting characters and modes
2
3
4
5
Teletext
▼
▼
▼
To select the Mode , with the Q button highlight
Mode .
With the S or R button choose AUTO or LIST.
Press EXIT to finish.
▼
▼
Back
Character CHARACTER-1
Mode AUTO
Press the TV MENU button and from the Set up
menu, use the P or Q button to highlight Teletext
and then the
R button to select.
With Character highlighted, use the R button to
select CHARACTER-1.
Before using teletext you can choose the correct alphabet
( Character ) and whether to view in LIST or AUTO mode,
(explained on the next page).
1
See page 34 for
details on the
remote control’s
teletext buttons…
Remember to
press the the
ATV/DTV button to
select ANAL
OGUE
mode.
!
TELETEXT