Toshiba 32ZT29B - Manual (Page 28)

28
Dolby Digital is available from DVD players, some games console players, etc. These must be connected
using a Scart or phono lead for the picture AND an optical or a coaxial cable for the sound see page 37.
Dolby Digital
Adjustments
Set the volume and balance of the front speakers to your preference. Play a Dolby
Digital source and press the TV MENU button on the TV’s remote control. Select the
Sound menu.
Press the Q button to highlight Surround and press R. Highlight the title, e.g. Dolby
Digital 3/2, which is an indication of the channels available from your current sound
source, see the table below.
Then press the R button and adjust the levels using the P or Q button to select the
centre and two rear speakers in turn. Press either the S or R button to adjust. The
number of adjustable speakers will depend upon the signal received from the DVD
player. To cancel the test press the EXIT button.
1
2
3
2
1
Press the TV MENU button and from the Feature
menu select Surround set up .
With Delay time highlighted, use the S or R button
to change the setting to a value that suits you.
Press EXIT when you have finished.
1
2
3
3
4
Dolby Digital
1/0 = Centre speaker only.
2/0 = Front Left and Front Right only.
2/1 = Front Left and Front Right +
Rear Left and Rear Right combined.
2/2 = Front Left and Front Right +
Independent Rear Left and Independent Rear Right.
3/0 = Front Left and Front Right and Centre.
No Rear Speakers.
3/1 = Front Left and Front Right and Centre +
Rear Left and Rear Right combined.
3/2 = Front Left and Front Right and Centre +
Independent Rear Left and Independent Rear Right.
Arrange the speakers around your normal viewing
positions (as shown on page 6) and then make sure that
the TV is set up as follows:
DELAY TIME…
If you sit a long way from the TV and close to the rear
speakers the sound from the rear will reach you before
the sound from the front. You can use a higher setting
in the Delay time option to restore the correct balance.
Alternatively, use the Test mode in the
Surround set up menu, see page 29.
If the DVD playing is recorded in Dolby P
ro Logic,
i.e. 4 channel stereo (front left, front right, centre
and rear) the TV will detect the 4 channels.
In this instance, when the Surround test
is run
the TV will cycle through the four channels
in use.
In order to get full Dolby Digital, the D
VD
player must be connected using the
coaxial or optical links.
!
The DVD/Games console is connected to the TV using
phono leads to the COMPONENT VIDEO INPUT or a
Scart lead to Scart 3, and an optical or coaxial cable to
the optical/coaxial sockets, DA-1 or DA-2.
The Digital input-1 (optical)/ Digital input-2 (coaxial)
in the AV connection menu (see page 25) is set to
EXT 3 if Scart 3 is used or EXT 4 if the equipment is
connected to COMPONENT VIDEO INPUT.
If external front speakers are connected
the external switch (found on the back
of the TV) is set to EXT. You will not hear the centre
channel without external front speakers connected.
Rear speakers are connected and the Rear speaker
option in the Surround set up menu is set to YES.
(See next page.)
Dolby Digital
SPECIAL SOUND FEATURES
If rear speakers are NO
T selected in the
Surround set up
menu, you will not hear any sound
from your rear speakers.
!