Texas Instruments 51X - Manual (Page 52)

5.3.2
Troubleshooting a Display Problem
If the LCD remains blank when you turn on the computer, and the status
indicators light, check the following controls on the display (refer to Figure
3-1):
•
LCD Standby mode - If the LCD backlight remains off, even with the
Brightness and Contrast Controls set to their highest positions (refer to
Section 3), the LCD may be in Standby Mode. Press the Standby or
Power button to resume the system.
•
Notebook Set for External Monitor - use CMOS Setup to reset notebook.
•
LCD - Replace the cover-display assembly as described in Section 6 of
this manual.
•
Low battery - Use a fully charged battery.
5.3.3 Fault Isolation Using Self Test
When the computer is first powered up, it automatically performs a self test
of its central hardware and memory functions. During self test (which lasts
for a few seconds), the display shows copyright and version number
information.
n
Note: Some procedures in this paragraph require you to use keystroke se-
quences, such as Ctrl-Alt-Del. To execute a keystroke sequence such as
this, you must press all three keys simultaneously.
5.3.3.1 Self Test Error Messages
Upon successful completion of the self test, the computer automatically
loads its operating system and other built-in utilities. If the self test fails to
complete successfully, the display shows one of the error messages
described in Appendix A.
5.3.4 PCMCIA Modem Problems
If an optional PCMCIA modem does not work properly, check the following
items:
•
Proper installation of any PCMCIA options (check Modem settings under
Control Panel).
•
Dialing problem or wrong number - Try dialing a number that you have
previously dialed successfully.
Troubleshooting 5-5