TANDBERG D1392602 - Manual (Page 28)

TANDBERG Video Portal Data port Command Interface User Guide
Dial This command establishes a dial out to an end point
Parameters:
• CalledParty: End point to be connected with the service.
• CallingParty: Service telephone number.
• NetType: Nettype of the end point to be called.
• CallType: Call type is either voice (Tlph), or voice and video (Vtlph).
OK Result parameter:
• Session ID:
Example:
xCommand Dial CalledParty:0612345678 CallingParty: 0207947123 Nettype: H324m Calltype:
Vtlph
*r Result (status=OK):
Dial: "dial:904023_5"
*r/end
OK
DialplanEntryDelete This command deletes the indicated entry of a dialplan.
Parameter:
• DialplanEntryNumber: <1..64>
Example:
xCommand DialplanEntryDelete: 1
*r Result (status=OK): /
*r/end
OK
DialplanEntrySwap This command swaps two dial plan entries in the dial plan list.
Parameters:
• DialplanEntryNumber: <1..64>
• DialplanEntryNumber2: <1..64>
Example:
xCommand DialplanEntrySwap 1 3
*r Result (status=OK):
*r/end
OK
DisconnectCall This command disconnects a call either via the Session ID or the Call Leg ID.
Parameter:
• CallID: Either the Call leg ID or the Session ID.
D1392602 28