TANDBERG D1392602 - Manual (Page 16)

TANDBERG Video Portal Data port Command Interface User Guide
• Gateway: Sets the gateway IP address. If a gateway is located on the LAN and the
Video Portal needs to reach nodes through this gateway, the gateway address can be set
using the gateway variable (the IP address of the gateway will be set automatically if the
Video Portal is in DHCP mode)
• Domain Name: Sets the domain name string of which the gateway is part of. Minimum
0, maximum 64 characters.
Example of IP Address feedback:
*c xConfiguration IP Address: "127.0.0.1"
Loadlimit Sets the processor-load percentage at which calls should be routed to another Video Portal.
LoadLimit: <0..100>
Example of Loadlimit feedback:
*c xConfiguration LoadLimit: 85
Services Displays all configured/uploaded .ivr-file services used in dial plans.
Services Service [1..64] Enabled:
Services Service [1..64] Name:
Services Service [1..64] ServiceFile:
Services Service [1..64] Logging: VP ONLY!!!!!!!!!!!!!
sub-commands:
• Enabled: : Enable the service.
• Name: : Specifies the name of the service.
• ServiceFile: Specifies which .ivr file is used as definition of this service.
• Logging: : Enables the service logging functionality.
Example of Service feedback:
*c xConfiguration Services Service 1 Enabled: On
*c xConfiguration Services Service 1 Name: "Direct Inwards Dialing"
*c xConfiguration Services Service 1 ServiceFile: "/tandberg/services/did.ivr"
*c xConfiguration Services Service 1 Logging: On
Session Sets a timeout time for sessions like telnet, ssh etc.
Session TimeOut: <0..65535>
Example of Session feedback:
*c xConfiguration Session TimeOut: 10000
SIP Configures the SIP Proxy Mode and Address settings.
SIP Mode:
or
SIP Interface Server Address
or
SIP Interface Server Type:
D1392602 16