Debug commands, Special (xcommand) commands, Special commands – TANDBERG D1392602 User Manual
Page 26
TANDBERG Video Portal
Data port Command Interface User Guide
Configuration:
PRI:41
TemperatureCelcius: NA
TemperatureFahrenheit: NA
*s/end
4.2.4. Debug Commands
Command: Desription:
Syslog
Enables a real-time log of Bonding, H.221 and H324m, ISDN, RTSP, IVider, and IVider Engine activity.
Note! H323 and SIP logging is presented using the following command:
tsh –a H323 (SIP).
Note! Logging via the serial port is limited by the speed of the serial port, which might result in loss of
logging data. Therefore, it is advised to use Telnet instead.
Syslog
Mask: With this Mask the logging of different components can be turned on. The
mask has to be used as a bit mask.
H324m: 1 (0x0001)
ISDN: 4 (0x0004)
RTSP: 8 (0x0008)
IVider: 16 (0x0010)
Engine: 64 (0x0040)
FileStreamer: 128 (0x0080)
ContentStreamer: 256 (0x0100)
Transcoder: 512 (0x0200)
Mux: 1024 (0x0400)
Cuil: 2048 (0x0800)
Medium: 1 (0x01)
High: 2 (0x02)
Show timestamp: 4 (0x04)
Show IP address: 8 (0x08)
Show Process: 16 (0x10)
Show Session ID: 32 (0x20)
For instance to view the logging of the H324m, Transcoder and IVider components, the mask value equals 1
+ 512 + 32 = 545
4.2.5. Special (Xcommand) Commands
Command: Description:
Boot
Reboots the system.
D1392602
26