Setting parameters (principle), Setting parameters (principle) – Tally Genicom 5040 User Manual
Page 57
User guide
Menu
49
Setting parameters
(principle)
Before you begin setting the parameters, you should check which pa-
rameters your system requires. Furthermore it is recommended to print
out the status page which contains the actual valid parameter values
(see
The start values, which are activated after switching on or after error
correction, are determined using the adjustable printer parameters. In
many cases these parameters are overwritten by means of a system ap-
plication.
Changed parameter settings are stored when the settings menu is quit-
ted and retain their values even when the printer is switched off.
Make sure that the printer is in menu mode (see section
Press the EJECT key to select next main menu or press the USER key
to select a previous main menu.
Press the STOP key to enter to the Parameter select mode. The LCD
displays the respective parameter and MENU.
Press the EJECT key to select a next parameter or press the USER key
to select a previous parameter.
Press the STOP key to enter the MENU setting mode.
EJECT
USER
SET UP
1
2
STOP
EJECT
USER
SET UP
1
2
STOP
EJECT
USER
SET UP
1
2
STOP
EJECT
USER
SET UP
1
2
STOP