4 − recording, Recording (either tape i or tape ii), Recording (either tape 1 or tape 2) – Tascam D00935220B User Manual

Page 17: Important safety instructions

IMPORTANT SAFETY INSTRUCTIONS

TASCAM 202

Recording (either TAPE 1 or TAPE 2)

1. Turn on the power.

2. Load a tape for recording.

Side “A” facing you

Press the

EJECT

key (

) to open the cassette

compartment. Insert the cassette tape with its
open edge facing down, side “A” facing you.
Then close the cassette compartment by push-
ing in the cassette door until it clicks shut.

NOTE

If the erasure prevention tabs of the loaded cas-
sette tape have been broken off, stick a piece of
adhesive tape over the hole(s).
With this cassette deck you can use Normal (Type
I) and Chrome (Type II) tapes for recording.

3. Set the

REV MODE

switch.

: Set to this position to record on one side

only.

: Set to either of these positions to

record on both sides.

•

4. Set the

DOLBY NR

switch.

Set the switch to

to record with Dolby Noise

Reduction.

Set to

OFF

to record without Dolby Noise Reduc-

tion.

5. Press the

RECORD

key.

The deck enters the record-pause mode.

and

will light on the display.

6. Adjust the recording level.

Start playback of your recording source and set
the

REC LEVEL

control knob so that the level

meter indicates “0 dB” at peaks.

7. Set the recording direction.

Recording is made in the direction indicated by
the play/record direction indicator (

). To

change this direction, press the opposite direction
play key (

NOTE

Be careful not to press play key whose arrow

points in the same direction as the indicator.
Doing so will start recording.

4 − Recording