Tascam D00935220B - Manual (Page 14)

IMPORTANT SAFETY PRECAUTIONS
1
TASCAM 202 MK IV
3 − Playback
3
3
Continuous playback can be performed between
TAPE 1 and TAPE 2. When one tape is played back to
the end, the other tape automatically starts playback,
in a relay fashion.
1. Load pre-recorded tapes into the TAPE 1 and
TAPE 2 compartments.
2. Set the DOLBY NR switch.
Always set the DOLBY NR switch to the same
position that was used for recording.
3. Set the REV MODE switch to the ä ( CONT
PLAY ) position.
4. Press the PLAY key ( ˙ or ¥ ) of the deck you
want to start first.
You can start continuous playback from either
TAPE 1 or TAPE 2.
Playback cycles through four tape sides as fol-
lows, and will continue until you stop the opera-
tion.
TAPE 1 Side“A” ∑ Side “B”
™ ≈
TAPE 2 Side “B” ß Side “A”
Continuous playback
Blank scan
The Blank Scan function detects 10 seconds or more
of blank and skips over it.
To activate this function, press the BLANK SCAN key
followed by the desired play key ( ˙ or ¥ ).
The BLANK SCAN indicator lights when this function is
activated.
To disable this function, press the BLANK SCAN key
again. The indicator turns off.
Very quiet passages in music are likely to be identified
as blanks. If you are worried about this, switch off
Blank Scan.