Tripp Lite HCRK-3 - Manual (Page 4)

4
Mounting
WARNING!
Mount the Power Supply Module and Battery Module BEFORE connection.
The mounting brackets are only designed to support a Tripp Lite Power Supply Module and a
single Battery Module. Do not mount or place any other devices on the mounting brackets.
The mounting brackets will not support the additional weight and may fail.
Failure to follow these warnings may lead to product damage and/or risk of personal bodily harm.
The mounting bracket is only designed to fit specific mobile medical cart configurations (see diagrams).
Tripp Lite offers additional mounting brackets for additional medical cart configurations. Contact Tripp Lite
for details. The user must determine the fitness of the mounting hardware and procedures before mounting.
If the hardware or procedures are not suitable for your application, contact Tripp Lite for assistance.
Power Supply Module &
Battery Module Mounting
Apply strips of double-sided tape to the sides of
the Power Supply Module and Battery Module
that will face down (see diagram for correct
orientation) when placed on the cart.
CAUTION!
The double-sided tape quickly
forms an extremely strong bond.
This ensures the modules will remain
securely in position, meeting the
requirements of demanding medical
environments. Due to the tape's strong bond,
position the modules exactly where desired
before pressing them into place.
Carefully lift Power Supply Module and Battery
Module, center them over the tray and press
down to bond the tape.
1
1
2
1A
1B
Remote User Interface
(RUI) Mounting
Mount the Remote User Interface in a
variety of positions on any flat surface using
included double-sided tape. Read caution
above concerning double-sided tape.
2
1A
1B
200608042 93-2618 Retrofit Kit 3 OM.qxd 9/14/2006 2:01 PM Page 4