Toshiba B-SP2D - Manual (Page 9)

- vii -
EO1-33038 Safety Precautions
• Do not charge the battery near flame or under direct sunlight. High
temperature may activate or damage the protection unit of the battery,
disabling the electric charge or causing it to overheat, burst, or burn.
• Unload the battery when the machine will not be used for a long
time. Failure to do this may cause machine failure.
• Keep the battery away from flame, a heat source or other locations
subject to high temperature.
Failure to do this may cause it to over heat or burn.
• Use the specified battery charger only. Failure to do this may cause
the battery to overheat, burst or burn.
• Do not force the battery into the machine or battery charger. Doing
so may cause the battery to overheat, burst or burn. Check for the
correct electrode.
• Do not connect the battery to a power outlet or a car cigarette lighter
jack as this may cause the battery to overheat, burst or burn.
• Because the B-SP2D-BT battery is exclusively for the B-SP2D printer,
do not use the battery in other machines. Doing so may damage
the battery or affect the performance and life of the battery.
Precautions
The following precautions will help to ensure that this machine will
continue to function correctly.
(1) Try to avoid locations that have the following adverse conditions:
* Temperatures below -5°C and above 40°C
* Direct sunlight
* Excessive vibration
(2) The cover should be cleaned by wiping with a dry cloth or a cloth
slightly dampened with a mild detergent solution. NEVER USE
THINNER OR ANY OTHER VOLATILE SOLVENT on the plastic
covers.
(3) USE ONLY TOSHIBA TEC SPECIFIED media.