Toshiba B-SP2D - Manual (Page 8)

- vi -
EO1-33038 Safety Precautions
• Be aware of the following precautions when using batteries. Otherwise
they could heat up, burst or burn.
■ Do not throw the battery into fire or heat it with a microwave or oven,
etc.
■ Do not load the battery with the electrodes reversed.
■ Do not connect the electrodes with metal objects like wire. Do not
carry or store the battery along with metal objects such as necklaces,
hairpins, etc.
■ Do not stick a needle into, hammer, step on, or drop the battery.
■ Do not solder the battery.
■ Do not leave the battery where the temperature is more than 60°
centigrade, such as inside a car or in direct sunlight.
This indicates that there is the risk of personal injury
or damage to objects if the machines are improperly
handled contrary to this indication.
CAUTION
• Keep away from flame or other sources of heat. Failure to do this
may cause fire or machine failure.
• Do not drop or shock the machine as this may cause machine
failure.
• During lightning, turn off and keep away from the machine
because of danger of electric shock and machine failure.
• Avoid locations subject to rapid change in temperature as this
causes condensation, causing electric shock or machine failure.
• Do not damage the print head, platen or strip roller with a sharp
object. Doing so may cause machine failure.
• Do not touch or contact the print head element with a metal object.
Doing so may cause machine failure.
• Use the specified media only. Failure to do this may cause machine
failure.
• Be sure to turn off the machine before replacing the battery, or
machine failure may occur.