Toshiba B-SP2D - Manual (Page 37)

8- 4
EO1-33038 8. ISSUING THE MEDIA
8. ISSUING THE MEDIA
3. Issuing media
• When issuing the labels in batch mode, the number of labels can be
specified. To re-issue the labels, press the FEED button.
This operation differs depending on the print mode.
• When issuing the labels in strip mode, the printer prints labels one by
one each time the FEED button is pressed.
Before issuing the next label, remove the printed label.
This operation differs depending on the print mode.
NOTE: Trim off the backing paper coming from the backing paper outlet.
• When issuing a receipt, press the FEED button after printed to feed it
to the position where it is easily cut. Each time the FEED button is
pressed, the receipt is fed for 20 mm.
4. Trim off the printed media upward or downward with the cutter.
NOTE: Do not pull the media toward the feed direction, as this will misalign
the print position of the next media.
Cutter