Toshiba Strata CIX IP5000-UG-VC - Manual (Page 179)

Administrator Programming
IP5131-SDL Settings
Strata CIX IP5000-series Telephone UG 07/09
161
Input Timer Mode Setting Screen
1. From the IP Configurations menu, select Others > Input
Timer Mode. The Input Timer Mode Setting screen
displays.
2. Press the On or Off soft keys to change the set value.
3. Press the Set soft key to accept the change.
...or press the Cancel soft key to cancel the change.
The changed setting is underlined in the Other Settings
screen display.
Input Timer Value Setting Screen
 From the IP Configurations menu, select Others >
Input Timer Value. The Input Timer Value screen
displays (shown right).
 To Change Information on this screen
1. Enter the New Input Timer to change the setting.
Note Use the dial pad 1~3 and
Vol
t to backspace.
Input Timer Value: 1 (fast) to 3 (slow)
2. Press the Set soft key to accept the change
...or press the Cancel soft key to cancel the change and
go to the Other Setting screen.
Notes
• Pressing the Set soft key can give you an Error Screen if you incorrectly entered
the timer value (outside of acceptable range).
• Press the Ok soft key on the Error Screen to correct the entry. Five seconds after
the Error Screen displays, the screen automatically goes back to the Input Timer
screen and the number that resulted in an error will display.
Input Timer Mode
On
Off
[Set] [Cancel]
Config
Input Timer Value
1
Backspace = Vol-Down
[Set] [Cancel]
Config
:Current
:New (1: Fast - 3:Slow)