Toshiba Strata CIX IP5000-UG-VC - Manual (Page 145)

Administrator Programming
IP Setup Instructions
Strata CIX IP5000-series Telephone UG 07/09
127
8. Press
FB6
to enter the CIX Strata Net node number of the CIX node that contains
the xIPU to which this IPT interfaces, then press
Hold
. This FB setting is for CIX
networked systems only.
9. Press
FB11
for xIPU IP address mode. Press one of the following:
1
: manual setting, then press
Hold
. Press
FB12
and enter the xIPU IP address,
then press
Hold
. (e.g., if the xIPU IP address is “192.168.1.241,” enter it in this
format
192 * 168 * 1 * 241
).
2
: auto setting by broadcast, then press
Hold
.
10. Press
Hold
again to set all the above data.
11. Go off-hook and hang up. The IP endpoint will search for the xIPU, initialize and
then set the IP address (from 20 sec. to 60 sec.). Time, Date and PDN displays on
LCD when the information is set.
Notes
• See Table 18 on page 129 for an explanation of the LCDs that you will see during
this procedure.
• If registration fails, check with the Administrator for the correct password (FB26).
 To manually set up the VLAN ID
The following steps are for manually setting the VLAN ID in an IPT. If this system is
not using VLAN tags or is using only the default (VID = 1) value, these steps are not
required.
1. Press
Hold
and then
3
+
6
+
9
+
Hold
(simultaneously). The display will show
“Program Select =”
2. Press
2
, then press the soft key Scrl until
FB21
is indicated.
3. Press
FB21
for VLAN Enable/Disable; 1 = Enable VLAN, 2 = Disable VLAN.
4. Press
FB22
to enter the VLAN ID (1 – 4094) for this phone.
5. Press
FB23
set the PC Port Type, 1 = Access, 2 = Trunk.
6. Press
FB24
to enter the PC Port VLAN ID (1 – 4094).