3 general use, General use – TANDBERG MXP User Manual
Page 31
3 General Use
Wake up the system
When the system is not in use, it is in standby mode and the screens are black. Wake up the
system by picking up the remote control. An incoming call or pressing any key on the remote
control will also wake up the system.
If the system does not respond:
Make sure that the system is switched on. The red light indicator below the internal LCD
should be turned on to indicate power on the system. If the system is not switched on,
you need to remove the codec cover on the rear of the pedestal in order to access the
power switch. Pull and lift the cover. The power switch is at the bottom of the Codec.
If the picture does not appear on your external display, but on the 5’’ internal LCD:
Check that the external display is turned on.
Check that video cable from Cesar is connected to external display
Make sure that the video settings on the external display are correct, read the user
manual for the external display.