TANDBERG MXP - Manual (Page 236)

TANDBERG Maestro MXP
236
Audio output connector specification:
Connector label Audio outputs
Signal type Unbalanced
Connector (codec) Female RCA/phono, sleeve-ground,
centre-signal
Output impedance 680 ohms
Max output level when set
to maximum output level
and volume control set to
max.
Max output level when set
to minimum output level and
volume control set to max. 15.5 Vpp
1.2 Vpp
Range, menu adjustable
output gain 22.5 dB (16 steps of 1.5 dB)*
Volume control attenuation
(audio out 1) 0 to 21 dB + mute (steps of 1.5 dB)
* Additional attenuation is possible on room/loudspeaker audio output using the volume control
setting
5.1.3 Network
Ethernet:
1 x Ethernet (RJ-45 Jack) LAN interface (10/100 Mb) up to 4 or 6 Mbps depending on the
bandwidth option installed.
To connect the system to a LAN, use the Ethernet cable provided by TANDBERG (or a standard
Ethernet cable).
The cable specification is:
1 ------------ 1
2 ------------ 2
3 ------------ 3
6 ------------ 6
If no LAN is available and the codec is connected directly to a computer, use a crossover cable.
The crossover cable specification is:
If such a connection is needed, the system and the PC must use ‘static’ TCP/IP settings because
no DHCP server is controlling the small “LAN”, which has been created between the computer
and the system. When configuring a back-to-back connection between the PC and the system,
make sure both static IP addresses exist on the same subnet.