Thermador 9000189697 - Manual (Page 5)

5
Installation options
There are many different installation options.
These are limited only by the design of the kitchen and
the function of the finger guard.
Individual unit
SideĆbyĆSide
* *
* Partition required!
i When 2 appliances are installed SideĆbyĆSide,
the Basic Combination SideĆbyĆSide Sealing kit
BSEALKIT10" must be used to ensure a stable
connection.
When combining 2 appliances with a freezing
function (e.g. 2 freezers or 1 bottom mount
appliance and 1 freezer), use the Extreme
Combination SideĆbyĆSide Heating kit
XHEATKIT10".
See the section on Optional accessories" on
page 11.
Individual appliances with partition
1. 2.
3. 4.
i Note
- When dimensioning the partition for model 4, note
the thickness of the furniture fronts to prevent
damage if the doors are opened at the same time.
- Use the Extreme Combination SideĆbyĆSide
Heating kit XHEATKIT10"
a) If the gap between the appliances is less than
6" (160 mm),
b) for permanent connection of two individual
appliances, e. g. Freezer or Bottom Mount
appliance next to Freezer.
See the section on Optional accessories" on
page 11.
- Minimum thickness of the partition 5 /
8
" (16 mm).
At the end of the kitchen units
If one side of the appliance is visible, a side panel must
be used.
The side panel must be connected firmly to the wall,
the floor and overhead furniture/fixtures before the
appliance is placed in the cavity.
The dimensions of the side panel are taken from the
opposite cavity wall. During installation ensure that the
cavity is square and the exact size.