Thermador 9000189697 - Manual (Page 22)

22
2 adjacent furniture doors can be attached instead of
one large door. These furniture doors must be
connected to a metal strip on the rear.
This metal strip can be purchased from customer
service as an optional accessory, see the section on
Optional accessories" on page 11.
When attaching the metal strip to the furniture doors,
observe the maximum possible length of the screws and
the position of the drill holes. Always screw into the best
loadĆbearing material of the furniture door.
i If only one furniture door is to be attached to the
door of a 30" or 36" wide appliance, attach the
supplied sandwich plate to the adjusting rail and
lock into position.
16. Loading the appliance door
When attaching the furniture doors, it is recommended
to load the door storage compartments in the appliance
with weights in order to ensure that the gap width is as
precise as possible.
Recommendations:
Refrigerator compartment
26 lbs / 12 kg (per door)
Freezer compartment 22 lbs / 10 kg
17. Attaching the adjusting rail
to the furniture door
(refrigerator compartment)
i The adjusting rail is the most important means of
adjusting the furniture front.
q Unscrew the installation support part from the
appliance doors.
q Remove the cover plate from the freezer
compartment door.
i Check the double threaded bolts on the adjusting
rail. Both of them must project out of the door by
3 /
16
" (5 mm).