Thermador 9000189697 - Manual (Page 11)

11
Required accessories and tools
1. Supplied accessories
- Installation instructions
- Operating instructions
- Installation kit
2. Optional accessories 8.
Basic Combination SideĆbyĆSide Sealing kit
BSEALKIT10"
For permanent connection of two individual appliances,
e. g. Freezer next to Refrigerator.
Extreme Combination SideĆbyĆSide Heating kit
XHEATKIT10"
a) If the gap between the appliances is less than
6" (160 mm).
b) For permanent connection of two appliances with a
freezing function, e. g. Freezer or Bottom Mount
appliance next to Freezer.
Extra long finger protection part
Panel unification part FPCONNTS10" (Metal strip)
For connection of two furniture doors.
3. Other required accessories
from specialist outlets
Ice maker installation kit ¼" OD copper line
For connecting appliances which require water, e.g. for
an ice maker.
i Maximum outer diameter of the water pipe
(without fittings): 13 /
32
" (10 mm).
4. Tools
- Cordless screwdriver T20
- Torx screwdriver T20
- Torx bit T20 + magnetic holder
-
5 /
16
" (8 mm) hex nut driver
- Wood drills in different sizes
- Open end wrench ½" (SW 13 mm)
- Multigrip pliers
- Adjustable wrench
- Cutter with adjustable blade
- Metal tape measure
- Square
- Spirit level length 2' (60 cm) and 4' (1,2 m)
- MarkingĆout level, length at least 4' (1.2 m) for
individual appliances or 7' (2.0 m) for SideĆbyĆSide
installation
5. Other
- Stepladder
- Dolly, hand truck
- Hammer drill
for drilling holes in wall or floor
- Bits according suitable for material and in different
sizes
- Wooden beam (cross section min. 3" x 4" (75 cm x
100 cm) as an alternative tilt protection, length
according to the width of the installation cavity
- Wooden screws in different sizes
- Thin (max.
1 /
16
" (1.5 mm)), suitable material to
protect the floor from damage (e.g. lino)
- Suitable material for covering and protecting
furniture (e.g. protective sheets)
- Adhesive tape