Thermador 9000189697 - Manual (Page 23)

23
q Measure the distance X between the adjusting rail
and the overhead furniture/fixtures.
q Mark this amount X on the rear of the furniture door.
q Determine and mark the centre of the furniture door.
q Loosen the 2 nuts and remove the adjusting rail.
q Put on the adjusting rail and align along the marks.
Mark the drill holes.
q Drill the holes.
q Screw on the adjusting rail tightly.
i Note
- Attach the adjusting rail to the furniture door with at
least 6 screws. One screw should be inserted under
each double threaded bolt.
- The adjusting rail features a variety of holes for the
many different design options of furniture doors.
Always screw into the best loadĆbearing material
of the furniture door.
18. Attaching and aligning
the furniture door
(refrigerator compartment)
i The double threaded bolts are responsible for
adjusting the height of the furniture front.
q Hang the furniture door on the double threaded
bolt.
q Align the furniture door with the double threaded
bolts (Torx screwdriver).