English – Philips FC7070 User Manual

Page 27

Problem

Possible cause

Solution

Water leaks from the

clean water tank because

you overfilled the clean

water tank.

Do not fill the clean water tank beyond the MAX

indication. If you do, water may spill from the clean

water tank when you fasten the cap (see chapter

‘Preparing for use’, section ‘Filling the clean water

tank’).

Water leaks from the

dirty water tank because

you tilted the upper

body too far backwards

or because you placed

the appliance on its side.

This caused wastewater

to run out of the dirty

water tank.

Do not tilt the upper body of the appliance too far

backwards, for instance when you clean under a low

table. Do not place the appliance on its side when

there is wastewater in the dirty water tank (see

chapter ‘Important’, section ‘Caution’).

I cannot remove

the mopping

brushes.

You probably tried to

remove them by pulling

at the wrong side.

grab the lime green grips of the brushes and pull

the brushes up a little. Then you should be able to

slide them off the projection on the other side (see

chapter ‘Cleaning and maintenance’, section ‘Cleaning

the mopping nozzle’).

I cannot tilt the

appliance back-

wards without

the nozzle com-

ing off the floor.

The appliance is locked in

parking position.

Press the parking position release button with your

foot to unlock the appliance from parking position

(see chapter ‘Using your AquaTrio’, section ‘Pausing

during use’).

The appliance

does not take

up water when

I flush the mop-

ping nozzle.

You poured too much

water into the flushing

tray or you poured it in

too fast. This causes the

mopping brushes to be-

come too wet. When the

brushes are too wet, the

active protection system

is activated. The mop-

ping brushes stopped

rotating because they

encountered too heavy

resistance.

Switch off the appliance, put the appliance upright in

parking position (‘click’), and pull the plug out of the

wall socket. Remove the mopping brushes from the

mopping nozzle and remove excess water from the

mopping brushes by squeezing them over a sink (see

chapter ‘Cleaning and maintenance’, section ‘Cleaning

the mopping nozzle’). Then you can reinsert the

mopping brushes, reinsert the mopping brush cover,

close the mopping nozzle lid and switch on the appli-

ance again (see chapter ‘Cleaning and maintenance’,

section ‘Reassembling the mopping nozzle’). If this

does not work, let the mopping brushes dry (see

chapter ‘Cleaning and maintenance’, section ‘Cleaning

the mopping nozzle’).

The tank full/

tank empty light

starts flashing

and the appliance

switches off while

flushing the mop-

ping nozzle.

The clean water tank is

empty.

Refill the clean water tank (see chapter ‘Preparing for

use’, section ‘Filling the clean water tank’) and start

the flushing procedure again (see chapter ‘Cleaning

and maintenance’, section ‘Flushing your AquaTrio’).

LISH