Philips FC7070 - Manual (Page 19)

19
8 Replacing the
mopping brushes
If you want to continue to benefit from your
AquaTrio’s cleaning results, make sure you always
use original Philips microfibre mopping brushes
and replace them every six months. If you follow
this advice, your AquaTrio will always provide you
with excellent cleaning results. For replacement
reminders, support, tips and tricks, register your
product online at www.philips.com/welcome
1
Switch off the appliance, place the appliance
upright in parking position (‘click’) and pull the
plug out of the wall socket.
2
Remove the old mopping brushes from the
mopping nozzle one by one (see chapter
‘Cleaning and maintenance’, section
‘Reassembling the mopping nozzle’).
3
Place two new mopping brushes into the
mopping nozzle one by one (see chapter
‘Cleaning and maintenance’, section
‘Reassembling the mopping nozzle’).
8.0.1 Important to know
• Always replace the two old mopping
brushes with two new mopping brushes at
the same time if you want to retain good
cleaning results.
• You can tilt the appliance backwards until
it leans on its wheels. Pull the appliance
backwards to move it.
7.2.1 Important to know
• Do not move the AquaTrio over a carpet,
as concentrated wastewater droplets may fall
from the mopping nozzle.
• Be careful if there is sand on the floor. If you
move the appliance over sand when it is
switched off, its wheels may scratch the floor.
• If you move the appliance across a hard floor
with the mopping nozzle placed on the floor,
the mopping brushes may leave a damp trace
on the floor.
EN
g
LISH