Tascam CD-DJ1 - Manual (Page 11)

IMPORTANT SAFETY INSTRUCTIONS
TASCAM CD-DJ1
11
Front panel
1 2 3
1 PHONES volume dial This dial adjusts the head-
phone output volume.
2
PHONES OUT jack This is a 1/4” (6.3 mm) stereo
headphone jack.
3 SETUP key Enter Setup menu mode by pressing
this key (see “Setup menu” on page 13).
Rear panel
1 2 3 4
1 Power switch This turns the CD-DJ1 power on
and off.
2
DC IN 9V jack Connect the supplied AC adapter
here.
3 TT-M1 jack Connects a separately sold TASCAM
TT-M1 scratch controller (see “TT-M1 use” on
page 22).
4
OUTPUT L/R jack (RCA pin jacks) These jacks
output the playback sound, and have a nominal
output level of –10 dBV.
2- Features of the CD-DJ1
Display features
The display shows the status of the CD-DJ1 and
information about the loaded disc. Normally, the
display shows the current settings and conditions, but
when the
SETUP key is pressed, the Setup menu is
shown.
The backlight brightness and display contrast can be
adjusted using the Setup menu (see “Adjusting the
backlight” and “Adjusting the contrast” on page 23).
1
78 9 0 q w
2 3 4 5 6
The “home” screen
1 Track number This shows the number of the cur-
rently selected track.
2
Total number of tracks During audio CD play-
back, the total number of tracks on the disc will
be shown.
During MP3 playback, depending on the Setup
menu FOLDER setting, the number of tracks in
the current folder or the total number of tracks on
the disc will be shown.