Tascam TEAC PROFESSIONAL M-164 - Manual (Page 7)

TASCAM M-164/M-164FX/M-164UF
7
2 − Names and Functions of Parts
1 ** USB indicator
Lights when the mixer is connected to a computer by
USB.
2 Input channel meters
Display the input level of each input channel (levels
after signals pass through the EQ section).
3 MONITOR (L, R) meters
Display the output signal level of the monitoring source
(stereo, SUB or AUX 1 bus) that has been selected with
the two switches at the
MONITOR section.
4 indicator
Lights when the mixer power has been turned ON using
the
ON/STANDBY switch on the rear panel.
5 +48V indicator
Lights when the phantom power has been turned ON
using the
PHANTOM (+48V) switch on the rear panel.
6 TRIM knobs (channels 1–6)
Use to adjust the input levels of signals from the MIC
and LINE input jacks. While observing the channel
meters above, turn to the left (toward LINE ) for line
level sources (electronic instruments, audio equipment,
etc.) or to the right (toward
MIC ) for microphones.
7 EQ section (channels 7-8, 9-10)
These channels each have a 2-band EQ.
The
EQ HI knob adjusts the high frequency range with
a roll-off frequency of 12 kHz and a boost/cut range of
±15 dB.
The
EQ LOW knob adjusts the low frequency range
with a roll-off frequency of 100 Hz and a boost/cut
range of ±15 dB.
Top panel
*
*
**
*
** M-164FX, M-164UF only
M-164UF only