Tascam TEAC PROFESSIONAL M-164 - Manual (Page 22)

22
TASCAM M-164/M-164FX/M-164UF
M-164 Series
mixer
AUX SEND 1 jack
AMP
PHONES jack
Stage
monitor
1 Turn ON (push in) the PRE switch under the AUX 1
knob of each channel that you want to monitor.
2 Use each channel’s AUX 1 knob to adjust the signal
level sent for monitoring.
3 Use the AUX MASTER 1 knob to adjust the overall
level sent to the AUX 1 send bus.
Using sub-group functions
By using the SUB bus as a sub-group, you can make
adjusting the stereo mix balance more efficient.
For example, in a live application when connecting drum
mics to channels 1–3, and inputting guitar, bass, and vocal
on channels 4–6, turn the
ST assign switches OFF and the
SUB assign switches ON for channels 1–3. Turn the ST
assign switches ON and the SUB assign switches OFF for
channels 4–6. Then turn the TO ST switch above the SUB
fader ON.
STEREO
OUTPUTS
jack
SUB
fader
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
STEREO bus
SUB bus
ST
fader
TO ST
switch
Drums
Guitar
Bass
Vocal
Channel
fader
With this setting, the guitar, bass and vocal signals are
sent directly to the stereo bus, but the drums signals pass
through the SUB bus before being sent to the stereo bus.
By doing this, after adjusting the balance of the three drum
mics, you can use the SUB fader to adjust the overall level
of the drums when balancing with the other sound sources.
4 − Using the mixer