TechniSat DigiCorder S1 - Manual (Page 30)

- display information on porogramme contents on
screen
- mark selected programmes which will be switched on
automatically at the starting time
- programme timers
- search for programmes according to type (genre), and
to select them for viewing.
7.14.1 Downloading SFI data
The programme information is updated at the time set on
your receiver in accordance with Point 8.2 (SFI channel. This
can only take place when your unit is in standby mode.
The downloading procedure is indicated by the message
Load SFI in the display. If your receiver is in operating mode
at this time, the download function will not be carried out.
You may also start the download procedure manually. First
switch off the receiver (display shows “Standby), then press
the SFI key. During the download procedure, the display will
show Load SFI, followed by an indicator of the SFI data
downloaded so far (e.g. 38%).
The duration of the download procedure depends on the
number of programmes available. Programmes can be shown
for up to seven days in advance. However, because of the
volume of data, this period is reduced the more porgrammes
are included in the electronic programme guide.
You can decide for yourself, which programmes should be
included in the electronic programme guide. These can be
included as described under Point 8.1.5.
7.14.2 Interrupting download procedure
You can interrupt the download procedure by switching on
the digital receiver (On/Standby key). The data from the pre-
vious SFI update will continue to be available.
7.14.3 Accessing electronic programme guide
> Switch on both the digital receiver and your television
set.
> Press the SFI key on the remote control of the digital
receiver.
The electronic programme guide will be displayed on
screen (Fig. 7-16). The display will show either the
current programmes of the channels selected by you,
or those included in the ex factory pre-programming
(see also Point 8.2). You can now use the SFI func-
tion to obtain information on the contents of various
programmes.
You can also use the SFI functions to select a pro-
gramme for viewing, to mark a programme for later
viewing, or to include it in timer programming.
30
(Fig. 7-16)
Bed_Anl_Digicorder_englisch 18.03.2004 14:10 Uhr Seite 30