Texas Instruments MSP-FET430 - Manual (Page 92)

MSP-FET430UIF Installation Guide
F-2
F.1 Hardware Installation
1) Connect the MSP-FET430UIF USB Debug Interface with a USB cable
to a USB port of your PC
2) Windows now should recognize the new hardware as an “MSP430
USB FET x.xx.xx” (Figure F-1).
Figure F-1. WinXP Hardware Recognition
3) The Hardware Wizard should start automatically and popup the “Found
New Hardware Wizard” dialog window.
4) Instruct the Wizard to install the hardware driver from a specific
location (Figure F-2).
Figure F-2. WinXP Hardware Wizard
5) Point the Hardware Wizard to the according folder where the
corresponding driver information files are located on your hard disc.