Texas Instruments MSP-FET430 User Manual
Page 15
Get Started Now!
1-3
MSP-FET430P430: Eight PCB 1x20 pin headers (Four male and four female).
MSP-FET430P440: Eight PCB 1x25 pin headers (Four male and four female).
One small box containing two or four MSP430 device samples.
MSP-FET430P120: MSP430F123IDW and/or MSP430F1232IDW
MSP-FET430P140: MSP430F149IPM and/or MSP430F169IPM
MSP-FET430P410: MSP430F413IPM
MSP-FET430P430: MSP430F437IPN and/or MSP430FG439
MSP-FET430P440: MSP430F449IPZ
Consult the device data sheets for device specifications. A list of device
errata can be found at http://www.ti.com/sc/cgi-bin/buglist.cgi
1.3 Kit Contents, MSP-FET430UIF
❏
❏
❏
❏
One READ ME FIRST document
❏
❏
❏
❏
One MSP430 CD-ROM
❏
❏
❏
❏
One MSP-FET430UIF interface module
❏
❏
❏
❏
One USB-Cable
❏
❏
❏
❏
One 14-conductor cable
1.4 Software
Installation
Follow the instructions on the supplied READ ME FIRST document to install the
IAR Embedded Workbench Kickstart. Read the file
information about the Workbench. The term Kickstart is used to refer to the
function-limited version of Embedded Workbench (including C-SPY debugger).
Kickstart is supplied on the CD-ROM included with each FET, and the latest
version is available from the MSP430 web site.
The above documents (and this document) can be accessed using:
START->PROGRAMS->IAR SYSTEMS->IAR EMBEDDED WORKBENCH
KICKSTART FOR MSP430 V3
Kickstart is compatible with WINDOWS 98, 2000, ME, NT4.0, and XP. However,
the USB-FET-Interface works only with WINDOWS 2000 and XP.
1.5 Hardware
Installation,
MSP-FET430X110
1) Connect the 25-conductor cable originating from the FET to the parallel port
of your PC.
2) Ensure that the MSP430F1121AIDW is securely seated in the socket, and
that its pin 1 (indicated with a circular indentation on the top surface) aligns
with the “1” mark on the PCB.
3) Ensure that jumpers J1 (near the non-socketed IC on the FET) and J5 (near
the LED) are in place. Pictorials of the FET and its parts are presented in
Appendix B.