TechniSat DigiBox IRDETO Integrated IRDETO User Manual
Page 35
>
Confirm with the
OK key.
>
Use the
up/down arrow keys to mark the entry Start search.
>
Press
OK again to start the search.
>
The search can be terminated at any time by pressing
OK.
It is quite likely that a full scan may take 15 minutes or longer.
Please note any notes and information displayed on the screen.
7.7.3 Transponder
This search mode can be used to search a specific transponder (see Point 9: Technical
Terms) for channels. In order to use this function, you will have to enter data relating to the
transponder.
>
Use the
up/down arrow keys to select the Transponder option.
>
Confirm with the
OK key.
The menu
>Search>Transponder will be displayed.
Satellite
In this line you must select the satellite corresponding to the selected transponder.
>
Use the
up/down arrow keys to select the Satellite option.
>
Press
OK to display a table listing four satellites.
>
Use the
up/down arrow keys to mark the selected satellite.
>
Confirm with the
OK key.
The selected satellite has now been acquired by the menu.
Transponder frequency
>
Use the
up/down arrow keys to mark the entry Transponder frequency.
>
Use the
numeric key pad to enter the correct frequency in this line.
Polarization
>
Use the
up/down arrow keys to mark the entry Polarization.
>
Use the
OK key to enter the polarisation plane (horizontal or vertical) on which the
desired programme is broadcast.
Symbol rate
The symbol rate indicates the volume of data transmitted per second. An example might be
27500, indicating transmission of 27500 symbols per second.
>
Use the
up/down arrow keys to mark the entry Symbol rate.
>
Use the
numeric key pad to enter the correct symbol rate.
>
Once you have entered all the information, start the search by using the
up/down
arrow keys to mark the entry Start search.
>
Confirm with the
OK key.
Please note any notes and information displayed on the screen.
7.7.4 Channel/Programme
If a channel cannot be found by means of any of the first three search modes, it may be
necessary to enter a programme-specific Service-ID-Number. This number will be obtainable
35
bed_anl_DigiBox Irdeto_englisch.qxd 30.01.02 12:03 Seite 35